Home  |  Contact Us  |  Mail: [email protected]
Home About Us News PRODUCTS Contact Us
Navigation
Press Room
行业 新闻
Social News
Contact Us
Add: Shimenqiao Military Camp Development Zone, Renqiu City, Hebei Province, China
Mail: [email protected]
Web: https://gear-chain.top
Your current location:Home > Press Room
Requirements for the adjustment of various parts of the machine tool during sprocket production
Release time: 2021-03-01 Article source: Views: 147

SprocketRequirements for the adjustment of various parts of the machine tool during production:

Adjust the stroke length and position of the planer:

Open the rocking table cover, loosen the nut on the eccentric crankshaft with a special wrench, adjust to the required stroke length according to the scale, and then tighten it.When adjusting the stroke position, loosen the fastening nut of the tool post ram, determine the position of the tool post ram according to the position of the processing gear, and then tighten it.
Adjust the saddle stroke amount:

It should be equal to the full tooth height plus the necessary clearance. This clearance is to ensure that the tool tip does not touch the part when dividing the tooth.But the gap should not be too large or too small, it should be controlled between 0.5 ~ 1mm.The adjustment of the saddle stroke can be carried out according to the machine scale value.

Adjust the end switch:
There is a disc behind the spindle of the workpiece box, and there is a scale value (0°~360°) on the periphery. This adjustment can ensure that the machine stops after cutting the ring gear.
Check the adjustment situation:
Check the correctness of the adjustment of the sprocket comprehensively, and especially check the sub-tooth.Start the machine tool during inspection (the workpiece is not in contact with the tool), stop immediately after the gear splitting mechanism performs gear splitting, and check the scale value on the disc behind the spindle of the workpiece box. At this time, it should be equal to 360° (for single gear splitting), that is It shows that the teeth are divided correctly.
Address: Shimenqiao Military Camp Development Zone, Renqiu City, Hebei Province, China Phone: 1380323165    
CopyRight © 2021 Ever Power all rights reserved